7: Services
SLC™ Console Manager User Guide 84
2. Enter the following fields:
3. Click the Apply button to save.
Admin Web Commands
The following CLI commands correspond to the wegb page entries described above.
To configure the timeout for web sessions:
admin web timeout <disable|5-120 minutes>
To configure the web server to use SSLv2 in addition to SSLv3 and TLSv1:
admin web protocol <sslv2|nosslv2>
Timeout Select No to disable Timeout.
Select Yes, minutes (5-120) to enable timeout.
Enter the number of minutes (must be between 30 and 120 minutes) after
which the SLC web session times out. The default is 5.
Note: If a session times out, refresh the browser page and login to a new web
session.
Enable iGoogle Gadget
Web Content
Select the check box to enable an SLC iGoogle gadget. The iGoogle gadget
allows an iGoogle user to view the port status of many SLC units on one web
page. (See iGoogle Gadgets on page 88.)
Allow SSLv2 Protocol Click the checkbox to support SSLv2 protocol. By default, the web supports the
SSLv3/TLSv1 protocol. Changing this option requires a reboot for the change to
take effect.
Cipher Click one of the radio buttons to configure the web to support low security (less
than 128 bits) or High/Medium security (128 bits or higher) for the cipher. By
default, the web uses High/Medium. Changing this option requires a reboot for
the change to take effect.
Group Access If undefined, any group can access the web. If one or more groups are specified
(groups are delimited by the characters ',' (comma) or ';' (semicolon)), then any
user who logs into the web must be a member of one of the specified groups,
otherwise access will be denied. Users authenticated via RADIUS may have a
group (or groups) provided by the RADIUS server via the Filter-Id attribute that
overrides the group defined for a user on the SLC or SLB unit. A group provided
by a remote server must be either a single group or multiple groups delimited by
the characters ',' (comma), ';' (semicolon), or '=' (equals) - for example
"group=group1,group2;" or "group1,group2,group3".
Banner The text to display on the web manager home page after the user logs in. May
contain up to 1024 characters (single quote and double quote characters are not
supported). Blank by default.
Note: To create additional lines in the banner use the \n character sequence.
Network Interfaces The interfaces that the web server is available on. By default, Eth1, Eth2 and
PPP interfaces on modems are enabled.
Web Sessions Click the Web Sessions link to view or terminate a web session. (See Services -
Web Sessions on page 85.)
SSL Certificate Click the SSL Certificate link to view, import or reset the SSL Certificate. ()
To Next Page
Loading...
Need help?
General