13: Maintenance
SLC™ Console Manager User Guide 230
Diagnostics
The Maintenance > Diagnostics page provides methods for diagnosing problems such as network
connectivity and device port input/output problems. You can use equivalent commands on the
command line interface. An additional diagnostic, loopback, is only available as a command.
1. Click the Maintenance tab and select the Diagnostics option. The following page displays:
Figure 13-7 Maintenance > Diagnostics
2. Select Diagnostics from checklist (one or more diagnostic methods you want to run, or select
All to run them all):
ARP Table Address Resolution Protocol (ARP) table used to view the IP address-to-hardware
address mapping.
Netstat Displays network connections. If you select the checkbox, select the TCP or UDP
protocol, or select All for both protocols to control the output of the Netstat report.
Host Lookup Select to verify that the SLC console manager can resolve the host name into an IP
address (if DNS is enabled). If selected, also enter a host name in the corresponding
Hostname field,
To Next Page
Loading...
Need help?
General