12: User Authentication
SLC™ Console Manager User Guide 188
5. Click the Apply button.
Note: You must reboot the unit before your changes will take effect.
RADIUS Commands
These commands for the command line interface correspond to the web page entries described
above.
To configure the SLC console manager to use RADIUS to authenticate users who log in via
the Web, SSH, Telnet, or the console port:
set radius <one or more parameters>
Parameters:
accessoutlets <Outlet List>
breakseq <1-10 Chars>
clearports <Port List>
dataports <Port List>
escapeseq <1-10 Chars>
listenports <Port List>
state <enable|disable>
To identify the RADIUS server(s), the text secret, and the number of the TCP port on the
RADIUS server:
set radius server <1|2> host <IP Address or Hostname> secret <Secret>
[port <TCP Port>]
The default port is 1812.
To set the number of seconds after which the connection attempt times out:
set radius timeout <disable|1-30>
May be 1-30 seconds.
To set user group and permissions for RADIUS users:
set radius group <default|power|admin>
To set permissions for RADIUS users not already defined by the user rights group:
set radius permissions <Permission List>
where
<Permission List> is one or more of nt, sv, dt, lu, ra, sk, um, dp, ub,
rs, rc, dr, wb, sn, ad, po, pc
USB Right to enter modem settings for USB. The USB checkbox is available for certain
SLC and SLB models.
PC Card Right to enter modem settings for PC cards. Includes managing storage PC cards.
The PC card checkbox is available for certain SLC and SLB models.
To Next Page
Loading...
Need help?
General