SLC™ Console Manager User Guide 250
15: Command Reference
This chapter lists and describes all of the commands available on the SLC command line interface
(CLI) accessed by using Telnet, SSH, or a serial connection. In addition to the commands, this
chapter contains the following sections:
Introduction to Commands
Deprecated Commands
The following is an alphabetical listing of categories and within each category there is a list of
commands in alphabetical order:
Introduction to Commands
This section explains command syntax, command line help, and tips for using commands. For
more detailed information about commands, see Command Line Interface on page 42.
Command Syntax
Commands have the following syntax: <action> <category> <parameters>. The <action> value
can be one of the following: set, show, connect, diag, pccard, admin, or logout. The <category>
value is a group of related parameters that you can configure or view. Examples are ntp,
deviceport, and network.
Administrative Commands Log Commands
Audit Log Commands Network Commands
Authentication Commands NFS and SMB/CIFS Commands
CLI Commands NIS Commands
Connection Commands PC Card Commands
Console Port Commands RADIUS Commands
Custom User Menu Commands Remote Users Commands
Date and Time Commands Routing Commands
Deprecated Commands Script Commands
Device Commands Services Commands
Device Port Commands Site Commands
Diagnostic Commands SLC Network Commands
Email Log Commands SSH Key Commands
Events Commands Status Commands
Group Commands System Log Commands
Host List Commands TACACS+ Commands
IP Filter Commands Temperature Commands
Kerberos Commands USB Commands
LDAP Commands User Permissions Commands
Local Users Commands VPN Commands
To Next Page
Loading...
Need help?
General