15: Command Reference
SLC™ Console Manager User Guide 313
show user [viewremoteperm <enable|disable>]
User Permissions Commands
Each user is a member of a group (default users, power users, administrators) and has a set of
user rights associated with the group. Additional user rights which are not defined by the group
may also be granted to them using the 'permissions' parameter.
The <Permission List> parameters is a comma-separated list of user rights to be added to or
removed from current permissions. Precede the two-letter acronym with a '-' to remove a user
right. For example, “nt,dt,-wb” adds Networking and Date/Time rights and removes Web Access
rights.
The following parameters assign user rights:
nt - configure Networking dp - configure Device Ports
sv - configure Services do - Device Port operations
dt - configure Date/Time pc - configure PC Cards
lu - configure Local Users um - configure User Menus
ra - configure Remote Authentication methods dr - view Diagnostics & Reports
rs - Reboot or Shutdown the SLC wb - Web Access
fc - manage Firmware and Configurations sn - configure Secure Lantronix Network
ad - full Administrative rights sk - configure SSH Keys
po - configure Power Outlets ub - configure USB
Note: For remote authentication methods, there is one group and set of user rights
defined for all users who login via a remote authentication method.
VPN Commands
Configure an IPsec VPN tunnel:
set vpn <parameters>
Parameters
tunnel <enable|disable>
name <VPN Tunnel Name>
ethport <1|2>
auth <rsa|psk>
remotehost <Remote Host IP Address or Name>
remoteid <Authentication Name>
remotehop <IP Address>
remotesubnet <one or more subnets in CIDR notation>
localid <Authentication Name>
localhop <IP Address>
localsubnet <one or more subnets in CIDR notation>
To Next Page
Loading...
Need help?
General