12: User Authentication
SLC™ Console Manager User Guide 196
3. In the User Rights section, select the user group to which TACACS+ users will belong.
4. Select or clear the checkboxes for the following rights:
Escape Sequence A single character or a two-character sequence that causes the SLC console
manager to leave direct (interactive) mode. (To leave listen mode, press any key.)
A suggested value is Esc+A (escape key, then uppercase "A" performed quickly
but not simultaneously). You would specify this value as \x1bA, which is
hexadecimal (\x) character 27 (1B) followed by an A.
This setting allows the user to terminate the
connect direct command on
the command line interface when the endpoint of the command is
deviceport,
tcp, or udp.
Break
Sequence
A series of 1-10 characters users can enter on the command line interface to send
a break signal to the external device. A suggested value is Esc+B (escape key,
then uppercase “B” performed quickly but not simultaneously). You would specify
this value as \x1bB, which is hexadecimal (\x) character 27 (1B) followed by a B.
Enable for Dial-back Select to grant a user dial-back access. Users with dial-back access can dial into
the SLC unit and enter their login and password. Once the SLC device
authenticates them, the modem hangs up and dials them back. Disabled by
default.
Dial-back Number The phone number the modem dials back on depends on this setting for the
device port. The user is either dialed back on a fixed number, or on a number that
is associated with the user’s login (specified here).
Data Ports
The ports users are able to monitor and interact with using the connect
direct
command.
Listen Ports
The ports users are able to monitor using the
connect listen command.
Clear Port Buffers
The ports whose port buffer users may clear using the
set locallog
clear
command.
Group Select the group to which the TACACS+ users will belong:
Default Users: This group has only the most basic rights. You can specify
additional rights for the individual user.
Power Users: This group has the same rights as Default Users plus Networking,
Date/Time, Reboot & Shutdown, and Diagnostics & Reports.
Administrators: This group has all possible rights.
Full Administrative Right to add, update, and delete all editable fields.
Networking Right to enter Network settings.
Services Right to enable and disable system logging, SSH and Telnet logins, SNMP, and
SMTP.
Secure Lantronix
Network
Right to view and manage Secure Lantronix units (e.g., SLP and Spider units) on
the local subnet.
Date/Time Right to set the date and time.
Local Users Right to add or delete local users on the system.
Remote
Authentication
Right to assign a remote user to a user group and assign a set of rights to the
user.
SSH Keys Right to set SSH keys for authenticating users.
User Menus Right to create a custom user menu for the CLI for TACACS+ users.
Web Access Right to access Web-Manager.
To Next Page
Loading...
Need help?
General