Maximum Rated RPM
6.2L (TowSport)
238 kW (320 hp) 5000–5400
275 kW (370 hp) 5000–5400
6. To test if the correct propeller has been installed, operate the boat (with normal load onboard) at WOT and check RPM
with an accurate tachometer. The engine RPM should be near the top of the specified range so that, under a heavy load,
the engine speed will not fall below specifications. If the engine speed is too high, replace the propeller with a higher pitch
propeller. Normally a 25 mm (1 in.) propeller pitch change causes an RPM change of 150 RPM.
7. Return to idle speed.
8. Shut off the engine.
9. Check the coolant level and add coolant if necessary.
Checking Shift Operation
With sterndrive unit installed and engine operating, ensure that the drive unit shifts properly, as explained following:
1. Shift into forward and reverse gear, ensuring that the clutch engages before the engine begins to accelerate.
2. Accelerate engine while in forward and reverse gear to ensure that the engine does not stop.
3. If the proper results are not achieved in the previous steps, shift cables must be readjusted.
4. Shifting from forward and reverse to neutral: ensure drive unit is in neutral before remote control shift lever comes to the
neutral detent position. Perform this check using various shifting rates to ensure that the drive unit shifts the same whether
shifting fast or slow.
Installation
90-8M0099748 eng DECEMBER 2015 © 2016 Mercury Marine Page 2B-51
To Next Page
Loading...
Need help?
General