Passport 12/Passport 8 Operator’s Manual 22-3
22.5 Stopping Report Printouts
To stop report printouts, select [Main Menu]→[Print Setup >>]→[Stop All Reports].
22.6 Setting Up Reports
22.6.1 Setting Up ECG Reports
You can print ECG reports only from the full-screen or half-screen. To set up ECG reports, select [Main Menu]→[Print
Setup >>]→[ECG Reports >>].
[Amplitude]: set the amplitude of the ECG waveforms.
[Sweep]: set the wave print speed to 25 mm/s or 50 mm/s.
[Auto Interval]: if [Auto Interval] is set to [On], the system will automatically adjust the space between waveforms
to avoid overlapping.
[Gridlines]: choose whether to show gridlines.
22.6.2 Setting Up Tabular Trends Reports
To set up tabular trends reports, select [Main Menu]→[Print Setup >>]→[Tabular Trends Reports >>].
[Start time]: you can set a time period whose trend data will be printed out by setting [From] and [Back]. For
example, if you set [From] as 2007-4-2 10:00:00 and [Back] as [2 h], the outputted data will be from 2014-4-2
08:00:00 to 2014-4-2 10:00:00. In addition, the [Back] can be set to either:
[Auto]: if [Report Layout] is set to [Time Oriented], the report will be printed by time. If [Report Layout] is set
to [Parameter Oriented], the report will be printed by parameter.
[All]: if you select [All], all trend data will be printed out. In this case, there is no need to set [From].
[Interval]: choose the resolution of the tabular trends printed on the report.
[Report Layout]: if you select [Time Oriented], the report will be printed by time. If you select [Parameter
Oriented], the report will be printed by parameter.
[Select Parameter >>]: from the pop-up menu, you can:
[Currently Displayed Trended Parameters]: print the parameter trend data selected from the [Tabular
Trends].
[Standard Parameter Group]: select the standard parameter group for printing.
[Custom]: define a parameter group for printing from the parameters displayed in the lower part of the menu.
To Next Page
Loading...
Need help?
General
