23-2 Passport 12/Passport 8 Operator’s Manual
23.4.1 Data Export System
You must install the data export system on the intended PC before performing the data transfer operation. Refer to the
document accompanying the installation CD-ROM for installation instructions.
The data transfer feature supports patient management, data review, data format conversion, print, etc. in addition to
data transfer. Refer to the help file of the system software for more details.
23.4.2 Transferring Data by Different Means
NOTE
Never enter the data transfer mode when the monitor is in normal operation or performs monitoring. You
must re-start the monitor to exit the data transfer mode.
Transfer data via a crossover network cable
Before transferring data using a crossover network cable:
1. Connect one end of the crossover network cable to the monitor and the other end to the PC.
2. Set the IP address of the PC. This IP address must be in the same network segment with that of the monitor.
3. Make sure that the data export system is active on the PC.
Then, follow this procedure to transfer data:
1. Select [Main Menu]→[Patient Data >>]→[Transfer Data].
2. Select [Yes] from the popup message box.
3. Input the IP address already set on the PC.
4. Select [Start] to start transferring data.
Transfer data within a LAN
Before transferring data within a LAN:
1. Connect the monitor and the intended PC into the same LAN and acquire the PC’s IP address.
2. Make sure that the data export system is active on the PC.
Follow the same procedure as via a crossover network cable to transfer data.
To Next Page
Loading...
Need help?
General
