Procedure
System Maintenance Section 5-3 D146/D147/D148/D149/D150
Firmware
5.3 PROCEDURE
§ A SD card is a precision device, so when you handle an SD card, respect the following.
§ When the power is switched ON, do not insert or remove a card.
§ During installation, do not switch the power OFF.
§ Since the card is manufactured to high precision, do not store it in a hot or humid location,
or in direct sunlight.
§ Do not bend the card, scratch it, or give it a strong shock.
§ Before downloading firmware on an SD card, check whether write-protection of the SD
card is canceled. If write-protection is enabled, an error code (error code 44, etc.) will be
displayed during download, and the download will fail.
§ Before updating firmware, remove the network cable from this machine.
§ If SC818 is generated during software update, switch the power OFF -> ON, and
complete the update which was interrupted.
§ During software update, network cables, remove interface cables, wireless boards, etc.,
(so that they are not accessed during update).
To Next Page
Loading...
Need help?
General
