Ricoh D148 User Manual

Error screens during updating
System Maintenance Section 5-9 D146/D147/D148/D149/D150
Updating the
Firmware
5.4 ERROR SCREENS DURING UPDATING
EXX shows an error code.
(This error is generated if update was performed when a printer application startup card is
removed after system startup. An error indicating failure of card access is displayed on the
screen.)
For error codes, refer to the following table:
Error Code List
Code Contents Solutions
20
Physical address mapping
cannot be performed.
1. Reinsert the SD card.
2. Replace the SD card.
21
Memory acquisition cannot be
performed.
1. Connect the HDD correctly.
2. Replace the HDD.
22
Compressed data
decompression failure.
The ROM update data in the SD card is
incorrect or damaged.
23
ROM update program startup
error
Controller program fault.
Controller program reinstallation, or
controller board replacement
24 Card access error
1. Reinsert the SD card.
2. Replace the SD card.
30
During print download, there
is no HDD.
1. Connect the HDD correctly.
2. Replace the HDD.
31
Data during download
continuation is not correct.
Insert the SD card containing continuation
target module data. Reinstallation required.
32
Data during download
interrupt is not correct.
Insert the SD card containing recovery
target module data after interruption.
Reinstallation required.

Ricoh D148 Specifications

General

Brand	Ricoh
Model	D148
Category	All in One Printer
Language	English