4.8.4 Displaying and editing settable zero offset
All settable offsets, divided into coarse and fine offsets, are displayed in the "Work offset -
G54...G599" window.
Rotation, scaling and mirroring are displayed.
Procedure
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
3. Press the "G54 … G599" softkey.
The "Work offset - G54 ... G599 [mm]" window opens.
Note
The labeling of the softkeys for the settable work offsets varies, i.e. the
settable work offsets configured on the machine are displayed (examples:
G54 … G57, G54 … G505, G54 … G599).
Please observe the information provided by the machine manufacturer.
4. You can edit the values directly in the table.
Note
Activate settable zero offsets
The settable zero offsets must first be selected in the program before they have an impact.
4.8.5 Displaying and editing details of the zero offsets
For each zero offset, you can display and edit all data for all axes. You can also delete zero
offsets.
For every axis, values for the following data will be displayed:
● Coarse and fine offsets
● Rotation
● Scaling
● Mirroring
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Setting up the machine
4.8 Zero offsets
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 149
To Next Page
Loading...
Need help?
General
