6. You can edit the values directly in the table.
- OR -
Press the "Clear offset" softkey to reset all entered values.
...
Press the "ZO +" or "ZO -" softkey to select the next or previous offset,
respectively, within the selected area ("Active", "Base", "G54 to G599")
without first having to switch to the overview window.
If you have reached the end of the range (e.g. G599), you will switch
automatically to the beginning of the range (e.g. G54).
These value changes are available in the part program immediately or after "Reset".
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Press the "Back" softkey to close the window.
4.8.6 Deleting a zero offset
You have the option of deleting work offsets. This resets the entered values.
Procedure
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
...
3. Press the "Overview", "Basis" or "G54…G599" softkey.
4. Press the "Details" softkey.
5. Position the cursor on the work offset you would like to delete.
Setting up the machine
4.8 Zero offsets
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 151
To Next Page
Loading...
Need help?
General
