14.6 Searching directories and files
You have the possibility of searching in the Program Manager for certain directories and files.
Note
Search with place holders
The following place holders simplify the search:
● "*": Replaces any character string
● "?": Replaces any character
If you use place holders, only directories and files are found that correspond exactly to the
search pattern.
Without place holders, directories and files are found that contain the search pattern at an
arbitrary position.
Search strategy
The search is made in all of the selected directories and their subdirectories.
If the cursor is positioned on a file, then a search is made from the higher-level directory.
Note
Searching in opened directories
Open the closed directories for a successful search.
Procedure
1. Select the "Program Manager" operating area.
2. Select the storage location in which you wish to perform the search and
then press the ">>" and "Search" softkeys.
The "Find File" window opens.
3. Enter the desired search term in the "Text" field.
Note: When searching for a file with place holders, enter the complete
name with extension (e.g. DRILLING.MPF).
4. When required, activate the "Observe upper and lower case" checkbox.
5. Press the "OK" softkey to start the search.
6. If a corresponding directory or file is found, then it is marked.
Managing programs
14.6 Searching directories and files
Milling
766 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
