N11 EXTCALL "ROLL" ;Call 5-;axis machining
;program with ;direc-
tion vectors ;(A3, B3,
C3)
N12 M2
10.6.2 Swiveling tool (CYCLE800)
10.6.2.1 Swiveling tool/preloading milling tools - only for G code program (CYCLE800)
After "Swivel plane", the tool orientation is always perpendicular on the machining plane. When
milling with radial cutters, it can make technological sense to set the tool at an angle to the
normal surface vector. In the swivel cycle, the setting angle is generated by an axis rotation
(max. +/- 90 degrees) to the active swivel plane. When setting, the swivel plane is always
“additive”. With "Setting tool", only rotations are displayed on the swivel cycle input screen
form. The user can freely select the rotation sequence.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Figure 10-19 The length up to the TCP (Tool Center Point) must be entered as tool length of the radial
cutter.
Programming technological functions (cycles)
10.6 Further cycles and functions
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 641
To Next Page
Loading...
Need help?
General
