You cannot accept the parameters if they are incomplete or obviously erroneous. In this case,
you can see from the dialog line which parameters are missing or were entered incorrectly.
Press the "OK" softkey.
- OR -
Press the "Accept" softkey.
2.4.8 Pocket calculator
The calculator allows you to calculate values for entry fields. It is possible to choose between
a simple standard calculator and the extended view with mathematical functions.
Using the calculator
● You can simply use the calculator at the touch panel.
● Without a touch panel, you can use the calculator using the mouse.
Procedure
1. Position the cursor on the desired entry field.
2. Press the <=> key.
The calculator is displayed.
3. Press the <min> key if you would like to work with the standard calculator.
- OR -
Press the <extend> key to switch to the extended view.
4. Input the arithmetic statement.
You can use functions, arithmetic symbols, numbers, and commas.
5. Press the equals symbol on the calculator.
- OR -
Press the "Calculate" softkey.
- OR -
Press the <INPUT> key.
The new value is calculated and displayed in the entry field of the calcu‐
lator.
6. Press the "Accept" softkey.
The calculated value is accepted and displayed in the entry field of the
window.
Introduction
2.4 User interface
Milling
52 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
