13.15 Settings for tool lists
The "Settings" window provides the following options to set the view in the tool lists:
● Display only one magazine in the magazine sorting
– You limit the display to one magazine. The magazine is displayed with the assigned
buffer locations and the not-loaded tools.
– You use a configuration to specify whether the "Magazine selection" softkey jumps to
the next magazine or whether the "Magazine Selection" dialog for changing switches to
any magazine.
● Display only spindles in the buffer
In order to display during operation only the spindle location, the remaining locations of the
buffer will be hidden.
● Enable tool in/out file
– When creating a new tool, the tool data can be loaded from a file.
– When deleting or unloading a tool, the tool data can be backed up in a file.
● Activating the adapter-transformed view
– The geometry lengths and the operation offsets are displayed transformed in the tool
list.
– The wear lengths and the sum offsets are displayed transformed in the tool wear list.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
References
Further information about configuring the settings are shown in the following reference:
SINUMERIK Operate Commissioning Manual
Procedure
1. Select the "Parameter" operating area.
...
2. Press the "Tool list", "Tool wear" or "Magazine" softkey.
Tool management
13.15 Settings for tool lists
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 735
To Next Page
Loading...
Need help?
General
