10.2 Milling
10.2.1 Face milling (CYCLE61)
Function
You can face mill any workpiece with the "Face milling" cycle.
A rectangular surface is always machined.
Workpieces with and without limits can be face-milled.
Approach/retraction
1. For vertical machining, the starting point is always at the top or bottom. For horizontal
machining, it is at the left or right.
The starting point is marked in the help display.
2. Machining is performed from the outside to the inside.
Machining type
The cycle makes a distinction between roughing and finishing:
● Roughing:
Milling the surface
Tool turns above the workpiece edge
● Finishing:
Milling the surface once
Tool turns at safety distance in the X/Y plane
Retraction of milling cutter
Depth infeed always takes place outside the workpiece.
For a workpiece with edge breaking, select the rectangular spigot cycle.
In face milling, the effective tool diameter for a tool of type "Milling cutter" is stored in a machine
data item.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Selecting the machining direction
Toggle the machining direction in the "Direction" field until the symbol for the required
machining direction appears.
● Same direction of machining
● Alternating direction of machining
Programming technological functions (cycles)
10.2 Milling
Milling
420 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
