15.8 Logbook
The logbook provides you with the machine history in an electronic form.
If service is carried out on the machine, this can be electronically saved. This means that it is
possible to obtain a picture about the "History" of the control and to optimize service.
Editing the logbook
You can edit the following information:
● Editing information on the machine identity
– Machine name/No.
– Machine type
– Address data
● Make logbook entries (e.g. "filter replaced")
● Deleting logbook entries
Note
Deleting logbook entries
Up to the 2nd commissioning, you have the option to delete all of the entered data up to
the time of the first commissioning.
Output of the logbook
You have the possibility of exporting the logbook by generating a file using the "Save version"
function in which the logbook is contained as section.
See also
Save information (Page 822)
15.8.1 Displaying and editing the logbook
Procedure
1. Select the "Diagnostics" operating area.
2. Press the "Version" softkey.
3. Press the "Logbook" softkey.
The "Machine logbook" window opens.
Alarm, error, and system messages
15.8 Logbook
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 823
To Next Page
Loading...
Need help?
General
