Hidden parameters
The following parameters are hidden. They are pre-assigned fixed values or values that can
be adjusted using setting data.
Parameter Description Value Can be set in SD
PL (only for G code) Machining plane Defined in MD
52005
SC (only for G
code)
Safety clearance 1 mm x
Reference point Position of the reference point: Center
Machining
position
Mill rectangular pocket at the programmed position (X0, Y0,
Z0).
Single posi‐
tion
α0 Angle of rotation 0°
Solid machining The rectangular pocket is milled from the solid material - (only
for roughing)
Complete
machining
Machine manufacturer
Please refer to the machine manufacturer's specifications.
10.2.3 Circular pocket (POCKET4)
Function
You can mill any circular pocket with the "Circular pocket" cycle.
The following machining methods are available:
● Mill circular pocket from solid material.
● Predrill circular pocket in the center first if, for example, the milling cutter does not cut in
the center (program the drilling, circular pocket and position program blocks in succession).
● Machine pre-machined circular pocket (see "Solid machining" parameter).
– Complete machining
– Post machining
The following machining types are available for milling using the "Circular pocket" function:
● Plane-by-plane
● Helical
Programming technological functions (cycles)
10.2 Milling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 429
To Next Page
Loading...
Need help?
General
