Tool type Additional parameters
700 Slotting saw Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Adapter length (length X, length Y, length Z)
Geometry (slot width, projection)
Wear (slot width, projection)
710 3D-probe milling Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
712 Mono-probe Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
713 L-probe Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Boom length (length)
714 Star-type probe Geometry length (length X, length Y, length Z)
Wear length (Δ length X, Δ length Y, Δ length Z)
Outer diameter (∅)
You can use the configuration file to specify the data to be displayed for specific tool types in
the "Additional Data" window.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1. The tool list is opened.
2. In the list, select an appropriate tool, e.g. an angle head cutter.
3. Press the "Additional data" softkey.
The "Additional Data - ..." window opens.
The "Additional data" softkey is only active if a tool for which the "Addi‐
tional Data" window is configured is selected.
13.5.2 Creating a new tool
When creating a new tool, the "New tool - favorites" window offers you a number of selected
tool types, known as "favorites".
If you do not find the desired tool type in the favorites list, then select the milling, drilling or
special tool using the corresponding softkeys.
Tool management
13.5 Tool list
Milling
702 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
