3. Press the "Relocate" softkey.
The "... relocate from location ... to location ..." window is displayed. The
"Location" field is pre-assigned with the number of the first empty maga‐
zine location.
4. Press the "OK" softkey to relocate the tool to the recommended magazine
location.
- OR -
Enter the required magazine, enter the location number and press the
"OK" softkey.
- OR -
Enter the number "9998" or the number "9999" into the "... magazine"
field in order to select the buffer as well as the required buffer location in
the "Location" field.
- OR -
Press the "Spindle" softkey to load a tool into the spindle and press the
"OK" softkey.
The tool is relocated to the specified magazine location, in the spindle or
in the buffer.
Several magazines
If you have set up several magazines, then the "...relocate from magazine... location... to..."
window appears after pressing the "Relocate" softkey.
Select the desired magazine and location, and confirm your selection with "OK" to load the
tool.
13.8.3 Deleting / unloading / loading / relocating all tools
You have the option of deleting or unloading all tools in the magazine list, loading them into
the magazine list or relocating them in the magazine list. With one task, the tools are deleted
or unloaded from the list or loaded, relocated in the list.
Requirement
The following requirements must be satisfied so that the "Delete all", "Unload all", "Load all"
or "Relocate all" softkey is displayed and available:
● Magazine management is set up
● There is no tool in the buffer / in the spindle
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Tool management
13.8 Magazine
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 721
To Next Page
Loading...
Need help?
General
