23.5.8.3 Deleting a program block
You can delete program blocks.
Procedure
1. The relevant block is selected and the "Program Block" window is open.
2. Select the block and press "Delete".
5. Press "OK" to delete the block.
- OR -
Press "Cancel" to abort the action.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
23.5.8.4 Inserting and editing networks
You can create a new network and then insert operations (bit operation, assignment, etc.) at
the selected cursor position.
Machine manufacturer
Please observe the information provided by the machine manufacturer.
The bit combinations comprise one or several logical operations and the assignment to an
output / bit memory.
If the cursor is moved further to the left with the arrow key, the type of assignment or a logic
operation can be selected. A further logic operation cannot be placed to the right of an
assignment. A network must always be terminated with an assignment.
Procedure
1. A block is selected.
2. Press the "Edit" softkey.
3. Position the cursor on a network.
4. Press the "Insert network" softkey.
- OR -
Press the <INSERT> key.
Edit PLC user program (828D only)
23.5 View of the program blocks
Milling
918 Operating Manual, 08/2018, 6FC5398-7CP41-0BA0
To Next Page
Loading...
Need help?
General
