Note
Copy/cut current line
To copy and cut the current line where the cursor is positioned, it is not necessary to mark or
select it. You have the option of making the "Cut" softkey only operable for marked program
sections via editor settings.
See also
Opening additional programs (Page 221)
6.10.4 Renumbering a program
You can modify the block numbering of programs opened in the editor at a later point in time.
Precondition
The program is opened in the editor.
Procedure
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumber" softkey.
The "Renumbering" window appears.
3. Enter the values for the first block number and the increment to be used
for numbering.
4. Press the "OK" softkey.
The program is renumbered.
Note
● If you only want to renumber a section, before the function call, select the program blocks
whose block numbering you want to edit.
● When you enter a value of "0" for the increment size, then all of the existing block numbers
are deleted from the program and/or from the selected range.
6.10.5 Creating a program block
In order to structure programs to achieve a higher degree of transparency, you have the option
of combining several blocks (G code and/or ShopMill machining steps) to form program blocks.
Machining the workpiece
6.10 Editing a program
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 219
To Next Page
Need help?
General
