The intermediate or interpolation point is only taught-in with geometry axes. For this reason,
at least 2 geometry axes must be set up for the transfer.
Note
Selection of axes for teach in
You can select the axes to be included in the teach-in block in the "Settings" window.
17.4.5 Teach-in A spline
For Akima-spline interpolation, you enter interpolation points that are connected by a smooth
curve.
Enter a starting point and specify a transition at the beginning and end.
You teach-in each interpolation point via "Teach in of position".
Software option
You require the "Spline-Interpolation" option for A Spline interpolation.
Note
The relevant option bit must be set to enable you to program a spline interpolation.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1. Select the "Machine" operating area.
2.
Press the <AUTO> or <MDA> key.
3. Press the <TEACH IN> key.
4. Press the "Teach prog." softkey.
Teaching in a program
17.4 Teach-in via window
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 855
To Next Page
Loading...
Need help?
General
