Display or hide all positions at once
1. Press the "Hide all" softkey to hide all positions.
2. Press the "Show all" softkey to display all positions again.
10.1.16 Repeating positions
Function
If you want to approach positions that you have already programmed again, you can do this
quickly with the function "Repeat position".
You must specify the number of the position pattern. The cycle automatically assigns this
number (for ShopMill). You will find this position pattern number in the work plan (program
view) or G-code program after the block number.
Procedure
1. The part program or ShopMill program to be processed has been created
and you are in the editor.
2. Press the "Drilling", and "Repeat position" softkeys.
The "Repeat positions" input window opens.
3. After you have entered the label or the position pattern number, e.g. 1,
press the "Accept" softkey. The position pattern you have selected is then
approached again.
Parameter Description Unit
LAB (only for G
code)
Repeat jump label for position
Position (only for
ShopMill)
Enter the number of the position pattern
Programming technological functions (cycles)
10.1 Drilling
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 419
To Next Page
Loading...
Need help?
General
