Parameter Description Unit
SP1 Tool alignment directly with the swivel axis
● 0
Direct entry of the angle
● fixed
Tool is fixed on the tool headstock
Note:
Please observe the information provided by the machine manufacturer.
Degrees
Hirth gearing
(only in the "align"
swivel mode)
Round β to the next Hirth gearing
Round up β to the next Hirth gearing
Round off β to the next Hirth gearing
Tool Tool tip position when swiveling
Tracking
The position of the tool tip is maintained during swiveling.
No tracking
The position of the tool tip is not maintained during swiveling.
Preferred direc‐
tion
Select the preferred swivel direction if the kinematics facilitates two sol‐
utions for the selected position of the tool with respect to the workpiece
Rotation plane Alignment of the rotation plane (with swivel mode "direct" or γ = fixed)
Standard
Mirrored
αC Align the plane of rotation in the pole position - (only in the "align" swivel mode and β
"zero degrees")
Degrees
10.6.4 High-speed settings (CYCLE832)
Function
The "High Speed Settings" function (CYCLE832) is used to preset data for the machining of
free-form surfaces so that optimum machining is possible.
The call of CYCLE832 contains three parameters:
● Machining type (technology)
● Axis tolerance
● Input of the orientation tolerance (for 5-axis machines)
Machining of free-form surfaces involves high requirements for both velocity and precision and
surface quality.
With the "High Speed Settings" function, you can achieve optimum velocity control depending
on the type of machining (roughing, rough-finishing, finishing). For this purpose, the cycle
Programming technological functions (cycles)
10.6 Further cycles and functions
Milling
Operating Manual, 08/2018, 6FC5398-7CP41-0BA0 647
To Next Page
Loading...
Need help?
General
