Compliance information
xx AFG31000 Series Arbitrary Function Generator User's Manual
Australia / New Zealand Declaration of Conformity – EMC
Complies with the EMC provision of the Radiocommunications Act per the following standard, in
accordance with ACMA:
CISPR 11:2009. Radiated and Conducted Emissions, Group 1, Class A, in accordance with
EN 61326-1:2013.
Safety compliance
This section lists the safety standards with which the product complies and other safety compliance
information.
EU declaration of conformity – low voltage
Compliance was demonstrated to the following specification as listed in the Official Journal of the
European Union:
Low Voltage Directive
EN 61010-1-2010. Safety Requirements for Electrical Equipment for Measurement, Control,
and Laboratory Use – Part 1: General Requirements.
EN 61010-2-030-2010. Safety Requirements for Electrical Equipment for Measurement,
Control, and Laboratory Use – Part 2-030: Particular requirements for testing and measuring
circuits.
Equipment type
Test and measuring equipment.
Safety class
Class 1 – grounded product.
Pollution degree descriptions
A measure of the contaminants that could occur in the environment around and within a product.
Typically the internal environment inside a product is considered to be the same as the external.
Products should be used only in the environment for which they are rated.
Pollution degree 1. No pollution or only dry, nonconductive pollution occurs. Products in this
category are generally encapsulated, hermetically sealed, or located in clean rooms.
Pollution degree 2. Normally only dry, nonconductive pollution occurs. Occasionally a
temporary conductivity that is caused by condensation must be expected. This location is a
typical office/home environment. Temporary condensation occurs only when the product is
out of service.
Pollution degree 3. Conductive pollution, or dry, nonconductive pollution that becomes
conductive due to condensation. These are sheltered locations where neither temperature
nor humidity is controlled. The area is protected from direct sunshine, rain, or direct wind.
Pollution degree 4. Pollution that generates persistent conductivity through conductive dust,
rain, or snow. Typical outdoor locations.
To Next Page
Loading...
Need help?
General
