Configuring Basic Features
439
No Answer Forward field.
2) Enter the destination number you want to forward all unanswered incoming
calls to in the Forward to field.
3) Press or , or the Switch soft key to select the ring time to wait before
forwarding from the After Ring Time field.
The default ring time is 12 seconds.
4) (Optional.) Enter the no answer forward on code and off code respectively in the
On Code and Off Code field.
You can also configure the no answer forward for all accounts. After the no answer
forward was configured for a specific account, do the following:
1) Press or to highlight the No Answer Forward field.
2) Press the All Lines soft key.
The LCD screen prompts “Copy to all lines?”.
3) Press the OK soft key to accept the change.
5. Press the Save soft key to accept the change.
To configure forward international via phone user interface:
1. Press Menu->Advanced (default password: admin) ->FWD International.
2. Press or , or the Switch soft key to select the desired value from the FWD
International field.
3. Press the Save soft key to accept the change.
Call Transfer
Call transfer enables IP phones to transfer an existing call to a third party. For example, if party A
is in an active call with party B, party A can transfer this call to party C (the third party). Then,
party B will begin a new call with party C and party A will disconnect.
IP phones support call transfer using the REFER method specified in RFC 3515 and offer three
types of transfer:
Blind Transfer -- Transfer a call directly to another party without consulting. Blind transfer
is implemented by a simple REFER method without Replaces in the Refer-To header.
Semi-attended Transfer -- Transfer a call after hearing the ringback tone. Semi-attended
transfer is implemented by a REFER method with Replaces in the Refer-To header.
Attended Transfer (Consultative Transfer) -- Transfer a call with prior consulting.
Attended transfer is implemented by a REFER method with Replaces in the Refer-To
header.
Normally, call transfer is completed by pressing the transfer key. Blind transfer on hook and
attended transfer on hook features allow the IP phone to complete the transfer through
on-hook.
When a user performs a semi-attended transfer, semi-attended transfer feature determines
To Next Page
Loading...
Need help?
General
