Yealink SIP-T2 Series User Manual

Setting Up Your System
35
Setting Up Your System
This section describes essential information on how to set up your phone network and set up your
phones with a provisioning server. It also provides instructions on how to set up a provisioning
server, how to deploy Yealink IP phones from the provisioning server, how to upgrade firmware,
and how to keep user personalized settings after auto provisioning.
This chapter provides the following sections:
 Setting Up Your Phone Network
 Setting Up Your Phones with a Provisioning Server
Setting Up Your Phone Network
Yealink IP phones operate on an Ethernet local area network (LAN) or wireless network. Local
area network design varies by organization and Yealink IP phones can be configured to
accommodate a number of network designs.
In order to get your IP phones running, you must perform basic network setup, such as IP
address and subnet mask configuration. You can configure the IPv4 or IPv6 network parameters
for the phone. You can also configure the appropriate security (VLAN and/or 802.1X
authentication) and Quality of Service (QoS) settings for the IP phone.
This chapter describes how to configure all the network parameters for IP phones, and it
provides the following sections:
 DHCP
 DHCP Option
 Configuring Network Parameters Manually
 Configuring Transmission Methods of the Internet Port and PC Port
 Configuring PC Port Mode
 Web Server Type
 Wi-Fi
 VLAN
 IPv6 Support
 VPN
 Network Address Translation (NAT)
 Quality of Service (QoS)
 802.1X Authentication

Yealink SIP-T2 Series Specifications

General

Brand	Yealink
Model	SIP-T2 Series
Category	IP Phone
Language	English