Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
116
Description
It configures the alignment mode of line key/ext key label.
Note: It is only applicable to T54S/T52S/T46S/T46G/T29G IP phones and EXP50 expansion modules con-
nected to the T54S/T52S IP phones. If some ext keys already exist before configuration, you need to
refresh the page (press the page keys, or try re-connecting the expansion module) to make the change
take effect.
Permitted
Values
0-the label and icon align left
1-when the line key/ext key is on the left side of the screen, the label and icon align left; when the line
key/ext key is on the right side of the screen, the label and icon align right
Default 0
Linekey Length in Short
Linekey length in short allows IP phones to shorten the line key label when the phone places a call, receives a call, is
during a call, or is idle (if large DND icon appears). You can configure the phone to display 2 characters or nothing. It is
only applicable to T52S IP phones.
The following figures show examples of label display:
Topics
Linekey Length Shorten Rules
Linekey Length in Short Configuration
Linekey Length Shorten Rules
If you configure the phone to display 2 characters, the display will match the rules below:
Label Short Label Description
Any string or Blank
Configured
(for example,
aLine1)
“Short Label” has higher priority than “Label”. If the value of “Short Label” is con-
figured, the value of “Label” is ignored.
Display the first two characters of the short label (for example, aL).
Configured
(for example, aLine1)
(for example, sunny)
Blank
• If the label contains uppercase characters or digits, only the uppercase char-
acters and digits are displayed. It displays two characters from left to right (for
example, L1).
• else, it displays the first two characters of the label (for example, su).
If both left blank, the default label is used. The display rule is the same as above.
Blank Blank
To Next Page
Loading...
Need help?
General
