Phone Provisioning
79
Description It enables or disables the long connection for downloading files via auto provisioning.
Permitted
Values
0-Disabled, the IP phone uses the short connection for downloading files via auto provisioning
1-Enabled
Default 0
Parameter static.auto_provision.authentication.expired_time <y0000000000xx>.cfg
Description
It configures the timeout (in seconds) after which the authentication pop-up box for auto provisioning
will disappear.
Permitted
Values
0-The authentication pop-up box will not disappear from the phone screen automatically.
Integer from 10 to 86400 -The authentication pop-up box will automatically disappear from the phone
screen after the designated time.
Default 7200
[1]
If you change this parameter, the IP phone will reboot to make the change take effect.
User-Triggered Provisioning Settings Configuration
You can enable the users to trigger IP phones to perform provisioning by dialing an activation code. This method
works only if there is no registered account on the IP phone.
The following table lists the parameters you can use to configure settings for user-triggered provisioning.
Parameter
static.autoprovision.X.name
[1][2]
<y0000000000xx>.cfg
Description It configures the code name to trigger auto provisioning.
Permitted
Values
String within 64 characters
Default Blank
Parameter
static.autoprovision.X.code
[1][2]
<y0000000000xx>.cfg
Description
It configures the activation code to trigger auto provisioning.
The activation code can be numeric characters, special characters # * or a combination of them.
Example:
static.autoprovision.1.code = 123
static.autoprovision.2.code = **
static.autoprovision.3.code = *123
Permitted
Values
String
Default Blank
Parameter
static.autoprovision.X.url
[1][2]
<y0000000000xx>.cfg
Description
It configures the access URL of the provisioning server for the IP phone to perform auto provisioning
which is triggered by activation code.
Permitted
Values
URL within 511 characters
To Next Page
Loading...
Need help?
General
