Phone Customization
119
Note: It is only applicable to T54S/T52S/T46S/T46G/T42S/T42G/T41S/T41P/T29G/T27G IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default 0
Web UI Dsskey->Line Key->Enable Page Tips
Expansion Module Page Tips
On expansion module EXP50, the page tips feature supports page switch key LED to indicate that BLF monitored user
receives an incoming call on the non-current page.
Topics
Expansion Module Page Tips Indicator
Expansion Module Page Tips Configuration
Expansion Module Page Tips Indicator
The following table lists the status of page switch key LED displayed on the expansion module:
Models LED Status Icons Description
EXP50 Flashing red / The BLF monitored user receives an incoming call on the non-current pages.
Expansion Module Page Tips Configuration
The following table lists the parameters you can use to configure expansion module page tips.
Parameter expansion_module.page_tip.blf_call_in.enable <y0000000000xx>.cfg
Description
It enables or disables the page switch key LED on the expansion module to indicate when BLF monitored
user receives an incoming call on the non-current pages.
Note: It is only applicable to EXP50 expansion modules connected to the T54S/T52S IP phones.
Permitted
Values
0-Disabled
1-Enabled
Default 1
Parameter expansion_module.page_tip.blf_call_in.led <y0000000000xx>.cfg
Description
It configures the page switch key LED status on the expansion module when BLF monitored user receives
an incoming call on the non-current pages.
This value uses the same macro action string syntax as an Enhanced DSS key.
If it is left blank, the default value takes effect.
Example:
expansion_module.page_tip.blf_call_in.led = $LEDr300o300$
It means an infinite loop for page switch key LED status: glow red for 300ms and then be in the off state
for 300ms.
Note: It works only if “expansion_module.page_tip.blf_call_in.enable” is set to 1 (Enabled). It is only applic-
able to EXP50 expansion modules connected to the T54S/T52S IP phones.