Call Features
289
Default 1
Auto Answer
Yealink IP phones support answering a SIP call or an IP address call automatically. Auto answer is configurable on a
per-line basis, while IP address call is not.
By default, the IP phones will not automatically answer the incoming call during a call or while dialing even if auto
answer is enabled; and the incoming call will not be automatically answered after you end the current call or cancel the
dialing. You can configure how the phone answers the call automatically.
Topic
Auto Answer Configuration
Auto Answer Configuration
The following table lists the parameters you can use to configure auto answer.
Parameter
account.X.auto_answer
[1]
<MAC>.cfg
Description
It enables or disables auto answer a SIP call.
Note: The IP phone cannot automatically answer the incoming call during a call or while dialing even if
auto answer is enabled.
Permitted
Values
0-Disabled
1-Enabled, the IP phone can automatically answer an incoming call.
Default 0
Web UI Account->Basic->Auto Answer
Phone UI
T54S/T52S/T48S/T48G/T46S/T46G/T29G:
Menu->Features->Auto Answer->Line X->Auto Answer
T42G/T42S/T41P/T41S/T40P/T40G/T27G/T23P/T23G/T21(P) E2/T19(P) E2/CP920:
Menu->Features->Auto Answer->Status
Parameter
account.X.auto_answer_mute_enable
(X is equal to 1)
<MAC>.cfg
Description
It enables or disables the auto answer mute feature.
Note: It is only applicable to CP920 IP phones. It works only if the values of parameters “account.X.auto_
answer” and “features.allow_mute” are set to 1 (Enabled). The value configured by this parameter takes
precedence over that configured by the parameter “features.mute.autoanswer_mute.enable”.
Permitted
Values
0-Disabled
1-Enabled, the IP phone will mute the microphone when an incoming call is automatically answered, and
then the other party cannot hear you.
Default 0
Web UI Account->Basic->Auto Answer Mute
Phone UI Settings->Features->Auto Answer->Account 1-> Auto Answer (On) ->Auto Answer Mute
To Next Page
Loading...
Need help?
General
