Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
164
linekey.1.label =Bill
######Set a Retrieve key####
linekey.3.type = 56
linekey.3.line = 1
linekey.3.value =*11
linekey.3.label =Retrieve Bill
After provisioning, you can easily press the Park key (line key 1) to park a call to the specific shared parking lot (*01)
during a call, and press the Retrieve key (line key 3) to retrieve the parked call from the shared parking lot (*01) using
the retrieve code (*11). You can only perform call park feature on the specific line (line 1).
If the “features.call_park.line_restriction.enable” is set to 0 (Disabled), the IP phone will park/retrieve the call to the
server on the current line in use.
Note
In Transfer call park mode, if you press the Park key when the phone is idle, the Park key will invoke the call park code.
Therefore, you can use a Park key to park and retrieve a call. In this case, you need to assign the park retrieve code (*11) to
“features.call_park.park_code”. When you press the Park key again on idle screen, the IP phone will dial out “*11*01” to
retrieve the parked call.
Example: Setting a Line Key as Directed Pickup key
Scenario Conditions Related Topic
account.1.direct_pickup_code = *97
or
features.pickup.direct_pickup_code = *97
Directed Call Pickup
Example
linekey.1.type = 9
linekey.1.line =1
linekey.1.value= 4603
linekey.1.label=Bill
After provisioning, you can easily press the Directed Pickup key (line key 1) to pick up an incoming call to a specific
phone (4603).
Note
The Directed Pickup invokes the directed pickup code by default. Therefore, the IP phone dials out *974603 to pick up a call.
If the directed code is not set, you can assign code and extension to “linekey.X.value”, for example, “*974603”.
Example: Setting a Line Key as Group Pickup key
The following example shows the configuration for a group pickup key.
Example
linekey.1.type = 23
linekey.1.line =1
linekey.1.value =*98
To Next Page
Loading...
Need help?
General
