Advanced Features
419
features.pickup.direct_pickup_code = *97
linekey.1.type = 16
linekey.1.line = 1
linekey.1.value = 1001
linekey.1.label = Bill
BLF Key Configuration
Example
features.pickup.blf_visual_enable = 1
features.pickup.blf_audio_enable = 1
When the monitored line receives an incoming call, the phone screen shows an incoming call to the monitored line
(e.g., “6001<-6002”, 6001 is the monitored extension which receives an incoming call from 6002) (from 1008 to 1001),
the following occurs on the phone:
l The phone plays a specific alert tone.
l The BLF key LED flashes red. On the T48S/T48G IP phone, the icon flashes.
l The caller ID appears on the phone screen.
The following shows visual alert for monitor line on T46S/T46G IP phones:
You can pick up the call to the monitored line, place a call to the monitored line, place a new call or back to the idle
screen.
LED Mode for BLF/BLF List Key
BLF LED Mode provides five kinds of definition for the BLF/BLF List key LED status. As there is no hard line key on
T48G/S IP phones, BLF LED mode configuration is applicable to any IP phones and expansion module, except T48G/S
and T19(P) E2/CP920 IP phones.
Topics
Supported BLF LED Modes
BLF LED Mode Configuration
Supported BLF LED Modes
The following table lists the LED statuses of the BLF/BLF list key when BLF LED Mode is set to 0, 1, 2, 3 or 4 respectively.
The default value of BLF LED mode is 0.
Line key/Expansion Module Key LED (configured as a BLF key or a BLF List key and BLF LED Mode is set to 0)
To Next Page
Loading...
Need help?
General
