STwrench User Guide Identifier
9836 4134 01 Edition 2.9 157 (326)
9.4 Scanning Identifiers with STwrench
Taking the set of the identifiers shown in the previous paragraph, here is the sequence needed to start a
Pset/Multistage/Job by reading the identifiers.
NOTE: The source program for the STwrench must be set to Barcode.
Identifiers
Work order
With the STwrench in the main menu, scan the first identifier (Type 2 in this example) in the specified
working order:
The wrench display shows that the first identifier (Type 2) in the given working order has been read. Scan
the next identifier:
To Next Page
Loading...
Need help?
General
