Atlas Copco STwrench User Manual

STwrench User Guide Pset
9836 4134 01 Edition 2.9 91 (326)
6.2 Angle Parameters
Start final angle
Torque threshold from which to start the angle count.
Min angle
Angle limit (low).
Max angle
Angle limit (high).
Alarm on rehit
Enable/disable the function to check if the screw is already tightened (defined via
the Check already tightened angle parameter).
Check already
tightened angle
If the torque reaches the Min. Torque value within this angle, the error message
“Already tightened” is shown on the wrench display:
This field is active only if the Alarm on rehit is enabled.
Concave-down
point threshold and
Concave-up point
threshold
Valid only for residual torque/angle strategy. See the Residual Torque/Angle
chapter for more information.
Min. torque
Min. angle
Max angle
Check already tightened angle

Atlas Copco STwrench Specifications

General

Brand	Atlas Copco
Model	STwrench
Category	Tools
Language	English