STwrench User Guide Working with ToolsNet
9836 4134 01 Edition 2.9 241 (326)
• Final Angle
• Final Angle Status
• Tool Serial Number: Serial number of the wrench smartHEAD
• Identifiers: Barcode readings
16.2.1 Sending traces to ToolsNet 4000
ToolsNet 4000 can retrieve the traces from the STwrench. For this mode the following prerequisites are
necessary:
- STwrench settings:
• The traces transfer to ToolsNet must be enabled (see previous paragraphs with
ToolsNet settings from ToolsTalk BLM)
• The wrench memory settings must be set for 10 traces of 30 seconds in length or 5
traces of 60 seconds in length. See the STwrench Settings → Memory chapter for more
information.
- QAT Node does not support the traces transfer; the STwrench must be connected directly to
ToolsNet via the IRC-W module or via Power Focus.
During operation, the traces are sent to ToolsNet after every tightening. If the connection STwrench-
ToolsNet is lost and the wrench reaches the maximum number of traces stored, the wrench shows the
message “Trying to send traces to Toolsnet... Please wait or press CL to cancel”. If you wait, the traces
will be transferred once the connection is re-established. If you instead pressing the CL button on the
wrench keyboard, the oldest traces will be deleted and replaced by the new ones.
To Next Page
Loading...
Need help?
General
