Cisco 4400 Series User Manual

4-89
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 4 Configuring Controller SettingsWireless Device Access
Configuring the Supervisor 720 to Support the WiSM
Loc Subscr Req: 0 Loc Subscr Rsp: 0
Loc Notif: 0
Loc Unsubscr Req: 0 Loc Unsubscr Rsp: 0
IDS Get Req: 0 IDS Get Resp: 0
IDS Notif: 0
IDS Set Req: 0 IDS Set Resp: 0
8. To clear the NMSP statistics, enter this command:
clear nmsp statistics
9. To view all mobility services active on the controller, enter this command:
show services mobility summary
Information similar to the following appears:
Mobility Services Subscribed:
Server IP Applications
--------- -------------
172.19.35.218 Client Tracking, Tag Tracking, Rogue Tracking,
Handover Client Tracking, FMC, AP Monitor, IDS
10. To view detailed mobility services information for all connections or for a specific connection, enter
this command:
show services mobility detail {all | IP_address}
Information similar to the following appears for the show services mobility detail all command:
Mobility Services Subscribed by 172.19.35.218 -
Application Services
----------- --------
Client Tracking RSSI, Info, Statistics
Tag Tracking RSSI, Statistics
Rogue Tracking RSSI, Info
Handover Client Tracking RSSI, Info,
FMC Handover
AP Monitor AP Status
IDS Services WIPS
Configuring the Supervisor 720 to Support the WiSM
When you install a WiSM in a Cisco Catalyst 6500 switch or a Cisco 7600 series router, you must
configure the Supervisor 720 to support the WiSM. When the supervisor detects the WiSM, the
supervisor creates ten Gigabit Ethernet interfaces, ranging from Gigslot/1 to Gigslot/8. For example, if
the WiSM is in slot 9, the supervisor creates interfaces Gig9/1 through Gig9/8. The first eight Gigabit
Ethernet interfaces must be organized into two Etherchannel bundles of four interfaces each. The
remaining two Gigabit Ethernet interfaces are used as service-port interfaces, one for each controller on
the WiSM. You must manually create VLANs to communicate with the ports on the WiSM.
Note The WiSM is supported on Cisco 7600 series routers running only Cisco IOS Release 12.2(18)SXF5.

Cisco 4400 Series Specifications

General

Brand	Cisco
Model	4400 Series
Category	Controller
Language	English