EasyManuals Logo
Home>Cisco>Controller>4400 Series

Cisco 4400 Series User Manual

Cisco 4400 Series
796 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #324 background imageLoading...
Page #324 background image
6-14
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Step 7 To specify the IP address of the optional DNS server(s), enter this command:
config dhcp dns-servers scope dns1 [dns2] [dns3]
Each DNS server must be able to update a client’s DNS entry to match the IP address assigned by this
DHCP scope
Step 8 To specify the IP address of the optional Microsoft Network Basic Input Output System (NetBIOS) name
server(s), such as a s Internet Naming Service (WINS) server, enter this command:
config dhcp netbios-name-server scope wins1 [wins2] [wins3]
Step 9 To enable or disable this DHCP scope, enter this command:
config dhcp {enable | disable} scope
Step 10 To save your changes, enter this command:
save config
Step 11 To see the list of configured DHCP scopes, enter this command:
show dhcp summary
Information similar to the following appears:
Scope Name Enabled Address Range
Scope 1 No 0.0.0.0 -> 0.0.0.0
Scope 2 No 0.0.0.0 -> 0.0.0.0
Step 12 To display the DHCP information for a particular scope, enter this command:
show dhcp scope
Information similar to the following appears:
Enabled....................................... No
Lease Time.................................... 0
Pool Start.................................... 0.0.0.0
Pool End...................................... 0.0.0.0
Network....................................... 0.0.0.0
Netmask....................................... 0.0.0.0
Default Routers............................... 0.0.0.0 0.0.0.0 0.0.0.0
DNS Domain....................................
DNS........................................... 0.0.0.0 0.0.0.0 0.0.0.0
Netbios Name Servers.......................... 0.0.0.0 0.0.0.0 0.0.0.0
Configuring MAC Filtering for WLANs
When you use MAC filtering for client or administrator authorization, you need to enable it at the WLAN
level first. If you plan to use local MAC address filtering for any WLAN, use the commands in this
section to configure MAC filtering for a WLAN.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 4400 Series and is the answer not in the manual?

Cisco 4400 Series Specifications

General IconGeneral
BrandCisco
Model4400 Series
CategoryController
LanguageEnglish

Related product manuals