Cisco 4400 Series User Manual

6-35
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Using the GUI to Configure QBSS
Using the controller GUI, follow these steps to configure QBSS.
Step 1 Click WLANs to open the WLANs page.
Step 2 Click the ID number of the WLAN for which you want to configure WMM mode.
Step 3 When the WLANs > Edit page appears, click the QoS tab to open the WLANs > Edit (Qos) page (see
Figure 6-14).
Figure 6-14 WLANs > Edit (QoS) Page
Step 4 From the WMM Policy drop-down box, choose one of the following options, depending on whether you
want to enable WMM mode for 7921 phones and other devices that meet the WMM standard:
• Disabled—Disables WMM on the WLAN. This is the default value.
• Allowed—Allows client devices to use WMM on the WLAN.
• Required—Requires client devices to use WMM. Devices that do not support WMM cannot join
the WLAN.
Step 5 Check the 7920 AP CAC check box if you want to enable 7920 support mode for phones that require
access point-controlled CAC. The default value is unchecked.
Step 6 Check the 7920 Client CAC check box if you want to enable 7920 support mode for phones that require
client-controlled CAC. The default value is unchecked.
Note You cannot enable both WMM mode and client-controlled CAC mode on the same WLAN.
Step 7 Click Apply to commit your changes.
Step 8 Click Save Configuration to save your changes.

Cisco 4400 Series Specifications

General

Brand	Cisco
Model	4400 Series
Category	Controller
Language	English