9-26
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 9 Managing Controller Software and Configurations
Saving Configurations
Step 8 If you are using an FTP server, enter these commands to specify the username and password used to log
into the FTP server and the port number through which the download occurs:
• transfer download username username
• transfer download password password
• transfer download port port
Note The default value for the port parameter is 21.
Step 9 To view the updated settings, enter this command:
transfer download start
Step 10 When prompted to confirm the current settings and start the download process, answer y. This example
shows the download command output:
Mode............................................. TFTP
TFTP Server IP................................... 10.10.10.4
TFTP Path........................................ Config/
TFTP Filename.................................... AS_4402_4_2_55_8_Config.xml
Data Type........................................ Config File
Encryption....................................... Disabled
**************************************************
*** WARNING: Config File Encryption Disabled ***
**************************************************
Are you sure you want to start? (y/N) y
File transfer operation completed successfully.
If the download fails, repeat this procedure and try again.
Saving Configurations
Controllers contain two kinds of memory: volatile RAM and NVRAM. At any time, you can save the
configuration changes from active volatile RAM to non-volatile RAM (NVRAM) using one of these
commands:
• save config—Saves the configuration from volatile RAM to NVRAM without resetting the
controller.
• reset system—Prompts you to confirm that you want to save configuration changes before the
controller reboots.
• logout—Prompts you to confirm that you want to save configuration changes before you log out.
To Next Page
Loading...
Need help?
General
