Cisco 4400 Series User Manual

3-18
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 3 Configuring Ports and Interfaces
Configuring Dynamic Interfaces
Using the CLI to Configure Dynamic Interfaces
Follow these steps to configure dynamic interfaces using the CLI.
Step 1 Enter show interface summary to view the current dynamic interfaces.
Step 2 To view the details of a specific dynamic interface, enter show interface detailed
operator_defined_interface_name.
Step 3 Enter config wlan disable wlan_id to disable each WLAN that uses the dynamic interface for
distribution system communication.
Step 4 Enter these commands to configure dynamic interfaces:
• config interface create operator_defined_interface_name {vlan_id | x}
• config interface address operator_defined_interface_name ip_addr ip_netmask [gateway]
• config interface vlan operator_defined_interface_name {vlan_id | 0}
• config interface port operator_defined_interface_name physical_ds_port_number
• config interface dhcp operator_defined_interface_name ip_address_of_primary_dhcp_server
[ip_address_of_secondary_dhcp_server]
• config interface quarantine vlan interface_name vlan_id
Note Use this command to configure a quarantine VLAN on any interface.
• config interface acl operator_defined_interface_name access_control_list_name
Note See Chapter 5 for more information on ACLs.
Step 5 Enter config wlan enable wlan_id to re-enable each WLAN that uses the dynamic interface for
distribution system communication.
Step 6 Enter save config to save your changes.
Step 7 Enter show interface detailed operator_defined_interface_name and show interface summary to
verify that your changes have been saved.
Note If desired, you can enter config interface delete operator_defined_interface_name to delete a
dynamic interface.

Cisco 4400 Series Specifications

General

Brand	Cisco
Model	4400 Series
Category	Controller
Language	English