6-54
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Step 4 Uncheck the Enabled check box for the Accounting Servers.
Step 5 Click Apply to commit your changes.
Step 6 Click Save Configuration to save your changes.
Disabling Coverage Hole Detection per WLAN
This section provides instructions for disabling coverage hole detection on a WLAN.
Coverage hole detection is enabled globally on the controller. See the “Coverage Hole Detection and
Correction” section on page 11-4 and the “Using the GUI to Configure Coverage Hole Detection”
section on page 11-15 for more information.
In software release 5.2, you can disable coverage hole detection on a per-WLAN basis. When you disable
coverage hole detection on a WLAN, a coverage hole alert is still sent to the controller, but no other
processing is done to mitigate the coverage hole. This feature is useful for guest WLANs where guests
are connected to your network for short periods of time and are likely to be highly mobile.
Using the GUI to Disable Coverage Hole Detection on a WLAN
Using the controller GUI, follow these steps to disable coverage hole detection on a WLAN.
Step 1 Click WLANs to open the WLANs page.
Step 2 Click the profile name of the WLAN to be modified. The WLANs > Edit page appears.
Step 3 Click the Advanced tab to display the WLANs > Edit (Advanced) page (see Figure 6-26).
Figure 6-26 WLANs > Edit (Advanced) Page
Step 4
Uncheck the Coverage Hole Detection Enabled check box.
To Next Page
Loading...
Need help?
General
