Cisco 4400 Series User Manual

6-52
Cisco Wireless LAN Controller Configuration Guide
OL-17037-01
Chapter 6 Configuring WLANsWireless Device Access
Configuring WLANs
Step 5 Set any additional parameters for 802.1X or WPA+WPA2.
Step 6 Click the Layer 3 tab to open the WLANs > Edit (Security > Layer 3) page (see Figure 6-24).
Figure 6-24 WLANs > Edit (Security > Layer 3) Page
Step 7
Choose None from the Layer 3 Security drop-down box.
Step 8 Check the Web Policy check box.
Step 9 Choose one of the following options to enable conditional or splash page web redirect: Conditional Web
Redirect or Splash Page Web Redirect. The default value is disabled for both parameters.
Step 10 If the user is to be redirected to a site external to the controller, choose the ACL that was configured on
your RADIUS server from the Preauthentication ACL drop-down list.
Step 11 Click Apply to commit your changes.
Step 12 Click Save Configuration to save your changes.
Using the CLI to Configure Web Redirect
Using the controller CLI, follow these steps to configure conditional or splash page web redirect.
Step 1 To enable or disable conditional web redirect, enter this command:
config wlan security cond-web-redir {enable | disable} wlan_id
Step 2 To enable or disable splash page web redirect, enter this command:
config wlan security splash-page-web-redir {enable | disable} wlan_id
Step 3 To save your settings, enter this command:
save config

Cisco 4400 Series Specifications

General

Brand	Cisco
Model	4400 Series
Category	Controller
Language	English