INVT SV-DA200 Series User Manual

SV-DA200 series AC servo drive Function codes
-140-
1. The default value 0 means no overvoltage protection;
2. The input voltage should be no more than 10V, otherwise damage may occur to the drive.
P3.25
Data size
32bit
Data format
DEC
Modbus address
1650, 1651
CANopen address
0x2319, 0x00
P3.26
1
Function selection of
analog input 1
Setting range
Default
Unit
Available mode
0–7
0
-
P
S
T
P3.27
1
Function selection of
analog input 2
Setting range
Default
Unit
Available mode
0–7
3
-
P
S
T
Select the analog input channel function via this parameter
Setting value
Definition
Unit
[0]
Invalid
-
1
Speed limit
r/min
2
Forward torque limit
0.1%
3
Speed command
r/min
4
Torque command
0.1%
5
Speed compensation
r/min
6
Torque compensation
0.1%
7
Negative torque limit
0.1%
P3.26
1
Data size
16bit
Data format
DEC
Modbus address
1652, 1653
CANopen address
0x231A, 0x00
P3.27
1
Data size
16bit
Data format
DEC
Modbus address
1654, 1655
CANopen address
0x231B, 0x00
P3.28
Analog speed
compensation gain
Setting range
Default
Unit
Available mode
0.0–100.0
0.0
%
P
Set the analog speed compensation gain via this parameter.
P3.28
Data size
16bit
Data format
DEC
Modbus address
1656, 1657
CANopen address
0x231C, 0x00
P3.29
Analog torque
compensation gain
Setting range
Default
Unit
Available mode
0.0–100.0
0.0
%
P
S
T
Set the analog torque compensation gain via this parameter.
P3.29
Data size
16bit
Data format
DEC
Modbus address
1658, 1659
CANopen address
0x231D, 0x00
P3.30
1
Analog output 1 function
selection
Setting range
Default
Unit
Available mode
0–19
0
-
P
S
T
P3.32
1
Analog output 2 function
selection
Setting range
Default
Unit
Available mode
0–19
0
-
P
S
T
This group of parameters is used to select the monitoring parameters to be outputted in analog

INVT SV-DA200 Series Specifications

General

Brand	INVT
Model	SV-DA200 Series
Category	Servo Drives
Language	English