INVT SV-DA200 Series User Manual

SV-DA200 series AC servo drive Running and operation
-85-
8. Setting of long parameters (corresponds to parameters with over 6 digits) in parameter area:
SHIFT
SHIFT
SHIFT
UP
DOWN
SET
UP DOWN
SHIFT UP
DOWN
SHIFT
SET
SHIFT
UP
DOWN
SET
MODE
5.2.2 State monitoring mode
After power on, the screen will enter into “General monitoring mode”, display the parameters name for
about 2.5 seconds and then display the current value. After pressing MODE key, UP/DOWN key can
be used to switch monitoring parameters. See chapter 10.3 Common monitoring parameter table for
details. The monitoring parameters displayed by default can be set via P0.15. If no operation is
carried out under interfaces other than parameter value display interface, it will return to the
monitoring parameter interface in 20 seconds.
Operation flowchart:
UP DOWN
DOWN
DOWN
UP
UP
MODE
Delay 2.5s or SET
MODE
Delay 2.5s or SET
MODE
Delay 2.5s or SET
5.2.3 Monitoring mode
MODE key can be used to switch into the monitoring mode. SHIFT key can be used to select the
group number of the monitoring parameters, UP/DOWN can be used to select the internal parameter
number and pressing for a long time, it can be used to select the parameter number quickly. After
finding the target, SET key can be used to view the current value and MODE can be used to return
the displaying interface. If no operation in R3 menu interface, it will return to the monitoring interface
in 20 seconds. If no operation in R0 and R1 menu interface, it will stay on the displaying interface.
Operation flowchart:

INVT SV-DA200 Series Specifications

General

Brand	INVT
Model	SV-DA200 Series
Category	Servo Drives
Language	English