INVT SV-DA200 Series User Manual

SV-DA200 series AC servo drive Function codes
-148-
This parameter is used to set the overvoltage protection value of analog input 3.
If the absolute value of analog input 3 voltage exceeds the set value, the system will report alarm.
P3.75
Data size
32bit
Data format
DEC
Modbus address
1750, 1751
CANopen address
0x234B, 0x00
P3.76
Analog input 3 filter
Setting range
Default
Unit
Available mode
0.0–1000.0
0.0
ms
P
S
T
This parameter is used to set the time constant of first order low-pass filter of analog input 3.
P3.76
Data size
16bit
Data format
DEC
Modbus address
1752, 1753
CANopen address
0x234C, 0x00
P3.77
Deadzone mode of
analog input
Setting range
Default
Unit
Available mode
0–1
0
-
P
S
T
Set the deadzone voltage mode of analog input by this parameter
Setting value
Definition
[0]
Normal mode
1
CNC mode. When AI is smaller than the deadzone, the valid value is 0:
When AI is larger than the deadzone, the valid value is AI-deadzone.
P3.77
Data size
16bit
Data format
DEC
Modbus address
1754, 1755
CANopen address
0x234D, 0x00
P3.90
Pulse input filter
Setting range
Default
Unit
Available mode
0–7
2
-
P
S
T
This parameter is used to set filter time of the pulse input.
Setting value
Width of pulse input
0
400kHz
1
500kHz
[2]
1MHz
3
2MHz
4
4MHz
5
No filter
6
200kHz
7
100kHz
P3.90
Data size
16bit
Data format
DEC
Modbus address
1780, 1781
CANopen address
0x235A, 0x00
P3.91
Reserved
Setting range
Default
Unit
Available mode
-
-
-
P
S
T
It is forbidden to modify this parameter.
P3.91
Data size
16bit
Data format
DEC
Modbus address
1782, 1783
CANopen address
0x235B, 0x00

INVT SV-DA200 Series Specifications

General

Brand	INVT
Model	SV-DA200 Series
Category	Servo Drives
Language	English