SV-DA200 series AC servo drive Running and operation
-79-
the stopping method through setting parameter P4.30. See description of P4.30 for details. This
process will not cause regenerative braking.
When a fault alarm occurs, the servo motor will stop. Select the stopping method of the servo
motor when an alarm occurs through setting parameter P4.30. See description of P4.30 for
details. This process will not cause regenerative braking.
When the digital input terminal configured as zero speed clamp (ZRS) is set to ON and P0.58 is
at non-zero value, the servo motor stops running. When P0.58 is set to 1–3, the motor stops
running based on the DEC time set by P0.55 and P0.57 in speed mode, and servo is in locked
state after stop; in torque mode, the servo motor stops running immediately. Such stopping
process may cause regenerative braking. If braking overload fault alarm occurred, please
connect to proper external braking resistor.
If the travel limit switch block function is invalid (parameter P3.40=0), and digital input terminal
signal configured as travel limit (POT/NOT) is set to ON, P0.55 and P0.57 of the servo motor
will immediately decelerate to stop based on the set value of P0.55 and P0.57. it will be in
locked state after stop. If reverse running command input is generated after motor stops, the
motor can run in reverse direction.
If the emergency stop switch block function is invalid (parameter P3.41=0), and the digital input
terminal configured as EMG is set to ON, the servo motor will coast to stop.
If the duration of servo disable signal is too short (less than 500ms), PWM signal may be in off
state once servo is enabled again.
To Next Page
Loading...
Need help?
General
